OSC Commands — Input

CueStudio 2 listens for OSC on UDP port 8000 by default. Change the port in Show Settings.

All addresses below are the full OSC path. Arguments are shown in parentheses where required.

#Transport

/cuestudio/go — fire GO (same as pressing the space bar)
/cuestudio/stop — stop the active cue
/cuestudio/pause — pause playback
/cuestudio/resume — resume after pause
/cuestudio/panic — full PANIC (stop all, blank video, DMX blackout)

/cuestudio/select/next — move the armed cue down one row
/cuestudio/select/previous — move the armed cue up one row

#Discovery (Zeroconf / Bonjour)

While OSC input is enabled, CueStudio advertises itself on the network as an _osc._udp service named "CueStudio (<this Mac's name>)", so controllers that browse for OSC devices — TouchOSC, OSC/PILOT and similar — can find it without you typing an IP address. You can always connect manually instead: the Show Settings header shows this Mac's IP, and the OSC tab shows the input port.

If the service doesn't appear in a controller's browse list, check System Settings ▸ Privacy & Security ▸ Local Network and make sure CueStudio 2 is enabled. Discovery is a convenience only — OSC keeps working over the IP address either way.

The web remote advertises separately as _cuestudio._tcp, and session sync as _cuestudio-session._tcp.

#Cue control

/cuestudio/cue/<number> — go to and fire that cue, e.g. /cuestudio/cue/5
/cuestudio/load/<number> — arm (load) that cue without firing it
/cuestudio/hotkey/<key> — fire the cue whose hotkey matches, e.g. /cuestudio/hotkey/A

#Playback position

/cuestudio/goto/time (float: seconds) — jump to a time position within the active cue

#Show state

/cuestudio/showmode (int: 0 or 1, optional) — set Show Mode on or off; omit the argument to toggle
/cuestudio/master/volume (float: 0.0 – 1.0) — set the grand master output volume as a linear gain
/cuestudio/master/db (float: dB) — set the grand master in dB, the value the fader shows. Send -30 for -30 dB. Anything at or below -60 is silence. Use this rather than the linear address when you are driving CueStudio from a console and thinking in dB.

#Queries (replies sent to the OSC output address)

/cuestudio/query/armed — replies with the armed cue number and name
/cuestudio/query/playing — replies with the playing cue number, name, and progress (0.0–1.0)
/cuestudio/query/cuecount — replies with the total number of cues in the active list